|2 vertical side pipe, 1 3/8 in.||2 black male hinge, 1 5/8 in.|
|2 horizontal top/bottom pipe, 1 3/8 in.||2 black female hinge, 1 3/8 in.|
|1 center support pipe, 1 3/8 in.||50 self-locking ties, 8 in.|
|4 black corner elbow, 1 3/8 in.||pack of hardware (2 carriage bolt, 16 self-tapping screw)|
|2 black end clamp, 1 3/8 in.||2 monofilament corner tension wire kit, 12 ga.|
|2 black fork assembly gate latch, 1 5/8 in.||2 wire clamp, 1/8 in.|
|2 side poles, 1 5/8 in. x 9 ft.||2 corner elbow, 1 5/8 in.|
|1 top spreader pole, 1 5/8 in.||8 elbow bolt, nut, and washer set|
Complete your deer fence installation with a professional and easy-to-install access gate. This 6-foot high access gate kit includes all of the hardware you need to assemble your gate frame, leaf, latches, and tensioning system, along with pictured instructions to guide you. This kit will create a 6-foot wide access gate that may be placed anywhere on your fence line for convenience.
Fencing material is not included in this kit and must be purchased separately to complete the installation.
Posted by Steve C on 1st Jul 2013
Hard to get everything level but do not race thru this measurement and squaring process.
Looks great when in place and using a 50 lb bag of Sakrete concrete mix all you do is pour the powdered concrete and add water like a cake -you do not even mix it! Be sure to support the poles until the concrete dries in about 20 minutes. Two small holes of 22 inches deep will take almost a whole bag.